LH-2510 Leveling Base Head You’re on steady ground™ 1
INTRODUCTION Thank You for choosing Oben! The Oben LH-2510 is a durable leveling base head and a superb solution for leveling a photo or video head independently of the tripod. It provides smooth and accurate leveling of a tripod head up to ten degrees in any direction. This leveling base head is designed for use with tripods that don’t have built-in levels.
TABLE OF CONTENTS Key Features 4 Operation 5 Mount Base to Tripod 5 Mount Head to Base 5 Leveling the Camera and Head 6 Specifications 6 Warnings 7 3
KEY FEATURES A B C D D E F A B C D E F 1/4″-20 threaded mounting post Fluid head (10° adjustment) Rubber mounting pad Tightening screws Bubble level Ratchet-style tightening screw G H I J K Rubber base pad 3/8″-16 treaded mounting socket 1/4″-3/8″ bushing 3/8″-1/4″ bushing Allen wrench I J K H G 4
OPERATION 1. Mount Base to Tripod Screw the leveling base head into the tripod until it is tight. Note: If the tripod has a 1/4″-20 threaded post, first screw the 3/8″ – 1/4″ bushing into the bottom socket and tighten with a flat head screwdriver. Then screw the base head into the tripod. 2.
OPERATION 3. Leveling the Camera 1. Turn the locking knob counterclockwise to loosen the leveling base. 2. Looking at the bubble level, adjust the level of the base until the bubble rests in the center of the circle. 3. Turn the locking knob clockwise to tighten and secure the leveling base.
OPERATION ! Warnings: • Please read and follow these instructions, and keep this manual in a safe place. • Do not attempt to attach the base head to a tripod with the camera attached. • Remove the camera setup from the leveling base head during setup or transport. • Do not exceed the head’s maximum load capacity of 25 lbs. (11.3 kg). • Ensure that all appropriate locks are engaged when necessary. • Do not operate in salt water. Dry the head if it becomes wet.
www.obensupports.
