User Manual

ManualsBrandsOben ManualsPhotographyDual-Action Mini Ball Head with Arca-Style Quick Release Plate

MBH-11

Dual-Action Mini Ballhead

You’re on steady ground

Summary of content (10 pages)

PAGE 1
MBH-11 Dual-Action Mini Ballhead You’re on steady ground ®
PAGE 2
INTRODUCTION Thank you for choosing Oben The Oben Dual Action Mini Ballhead is an ideal accessory for most tabletop and mini tripods. Lightweight yet strong and durable, this all-metal ballhead boasts professional features that are more often found in full-sized ballheads. The MBH-11 is outfitted with an Arca-compatible quick-release plate for rapid camera mounting and swapping.
PAGE 3
SPECIFICATIONS /WARNINGS Maximum Load 11 lb. (5 kg) Base Diameter 1.2 in. (30 mm) Height 2.9 in. (7.4 cm) Weight 5.35 oz. (152 g) ! Warnings: • Do not exceed the ballhead’s maximum load capacity (see Specifications). • Ensure that all appropriate locks are engaged when necessary. • This ballhead should be used only in temperatures between -22°F and 140°F (-30°C and 60°C). • Remove the camera from the ballhead during transport.
PAGE 4
OVERVIEW B C A D J E 45 I 30 15 0 15 30 45 60 H G A Quick-release plate B 1/4-20 mounting screw C Quick-release knob D Vertical bubble level E Main locking knob F Reducer bushing G 3/8-16 threaded socket H Panoramic base with 360° markings I Pan locking knob J 90° notch F
PAGE 5
OPERATION Mounting the Ballhead Screw the ballhead onto the tripod’s mounting post. Note: If the tripod has a 3/8-16 mounting post, remove the reducer bushing from the ballhead’s mounting socket.
PAGE 6
OPERATION Mounting the Quick-Release Plate The quick-release plate has a 1/420 screw that fits most cameras. 1. Loosen the quick-release knob by turning it counterclockwise, and remove the quick-release plate from the ballhead. 2. Screw the plate onto the bottom of the camera. 3. Use the D-ring, a slotted screwdriver, or a coin to tighten the screw into the camera’s socket.
PAGE 7
OPERATION Mounting the Camera Make sure all knobs on the ballhead are tightened, except for the quick-release knob. 1. Turn the quick-release knob counterclockwise until it stops. 2. Mount the camera to the ballhead by sliding one edge of the quick-release plate into the clamp. Then lower the other side until the quick-release plate is lying flat in the quickrelease clamp. Note: Make sure the mounting screw’s D-ring is flush with the bottom of the plate. 3.
PAGE 8
OPERATION Main Locking Knob Operation The main locking knob locks and unlocks the ballhead, which allows you to change the position of the camera. A lways use one hand to secure the camera while adjusting the ballhead, and make sure the lock is engaged before letting go of the camera. Note: To adjust the tension in a tight space, or if something is blocking you from turning the knob, pull the knob out, reposition it so it can turn without interference, and release it.
PAGE 9
OPERATION Panoramic Base The base of the ballhead can be independently rotated 360°. Use the degree markings on the base of the ballhead to accurately set up panoramic shots. 1. Twist the pan knob counterclockwise to unlock the base. 2. Rotate the base to the desired position, and then lock the base by turning the knob clockwise.