2018.1

PlanetPress Workflow 8 can be installed in parallel on the same machine as an existing
PlanetPress® Suite 7.x installation.
Note however:
l If both versions need to be hosted on the same machine, PlanetPress Workflow 2018.1
must always be installed after the legacy PlanetPress® Suite 7.x installation.
l When uninstalling PlanetPress Workflow 2018.1, you may be prompted to repair your
legacy PlanetPress® Suite 7.x installation.
l If PlanetPress Workflow 2018.1 has been installed alongside PlanetPress® Suite 7,
Capture can no longer be used with Workflow 7.
The plugins are now registered uniquely to Workflow 2018.1 and the messenger for
Workflow 7 is taken offline. It is only then possible to use Capture from PlanetPress
Workflow 2018.1.
l PlanetPress Workflow 2018.1 and PlanetPress® Suite Workflow 7 cannot run
simultaneously, since only one version of the Messenger service can run at a time. In fact,
no two versions of Workflow can be run simultaneously on the same machine, regardless
of versions.
l It is possible to switch between different versions running by shutting down one version's
services and then starting the other. However, this is not recommended. There are no
technical limitations that prevent processes from previous PlanetPress Suite Workflow
versions (as far back as Version 4) to run on PlanetPress Workflow 8, removing the need
to run both versions.
For more information on the licensing of Workflow 2018.1, please see Activating your license.
Upgrading from PlanetPress Suite 6/7
Note
This document is intended for people who already received their upgrade to PlanetPress Connect.
They should already have their new serial number(s) in hand and the PlanetPress Connect installers.
With the release of PlanetPress Connect, Objectif Lune’s innovative new technology, existing
users of PlanetPress Suite version 7 and 6 have the possibility to migrate to an introductory
version of PlanetPress Connect called “PlanetPress Connect Print-Only”.
Page 64