2020.1

Imposition
An Output Creation Preset can tell a printer to print multiple pages on a single sheet (Simplex,
or Duplex). This is called Imposition, also known as N-Up printing.
The two Imposition types are Cut & Stack and Stack by Column (see "Imposition options" on
page1222).
With each Imposition type there is a wide range of options to control the exact layout of the
output: the number of pages that go on one sheet, their order, the way they are stacked, the
stack depth, the margins, markings, etc.
Note that when Imposition is used, the possibilities to separate the output (see "Separation"
below) and to add additional content ("Additional content" on the next page) are limited. Groups
and meta data on lower levels than the Job Segment level (as defined in a Job Creation Preset)
are no longer available after the Imposition process.
Booklet Imposition
Booklet Imposition defines how to generate booklets in the output (see "Booklet Options" on
page1221).
As printing booklets implies printing multiple pages on a single sheet, this is used in
conjunction with some Imposition settings.
Separation
The print output can be split - 'separated' - into discreet portions. An Output Creation Preset can
either separate documents, document sets, job segments or jobs, or it can split the output
between counts of sheets, documents, document sets or job segments. In addition the preset
can tell the printer to add slip sheets and/or jog the output. See "Separation options" on
page1246.
Using document sets, job segments or jobs in the Separation settings requires that
documents in the print job be grouped that way in advance, following the instructions in a Job
Creation Preset (see "Grouping" on page1423).
Note
Separating the output using Grouping on levels lower than the Job Segment is not
Page 1426