2020.1

Viewing step details
Hovering over the task shows a tooltip that displays some of the details of that step. To see all
details for a step, click on the step and take a look at the Step properties pane ("Step properties
pane" on the next page).
Clicking on any Extract step in the Steps pane highlights any area in the Data Viewer from
which it extracts data.
You can also click on the Preprocessor step to select all the steps in the workflow to show a
complete map of all the extracted data.
Window controls
The following controls appear at the top of the Steps pane:
l
Zoom In (CTRL +) : Click to zoom in by increments of 10%
l
Zoom Out (CTRL -) : Click to zoom out by increments of 10%
Contextual menu
You can access thecontextual menu using a right-click anywhere inside the Steps pane.
l
Add a Step: Adds a step to the process. More options are available when a Repeat or a
Condition step is selected:
l
Add Step in Repeat: Adds a step to a Repeat loop.
l
Add Step in True: Adds a step to the True branch of a Condition step.
l
Add Step in False: Adds a step under the False branch of a Condition step.
l
Add Multiple Conditions Step: Adds a Multiple Conditions step.
l
Add Case Step: Adds a Case condition under the selected Multiple Conditions
step.
l
Ignore Step/Reactivate Step: Click to set the step to be ignored (aka disabled) or to
reactivate it. Disabled steps are grayed and do not run, neither in the DataMapper nor
when the data mapping configuration is executed in Workflow. However, they can still be
modified normally.
l
Delete Step: To remove a step, right-click on it and select Delete step from the contextual
menu or use the Delete button in the Toolbar. If the step to be deleted is Repeat or
Condition, all steps under it will also be deleted.
Page 328