2022.1

l Licensed speed limit (pages per minute): This read only entry shows the current
license speed limitations, in pages per minute. The speed limitations are determined by
your Connect license.
This information is to help you choose what settings would make sense when assigning
the “Target speed” values later in the Tab.
l Licensed tasks limit: This read only entry shows the current license task (or job)
limitations.
Note
The terms "job" and "task" can be used interchangeably.
l Total Weaver engines configured: This read only entry shows the total number of
Weaver engines available. To change this value, you must update the amount of Weaver
Engines in the Engines preferences page.
Job sizes group:
These two settings allow you to define what type of jobs are to be considered Small jobs and
what types are to be considered Large. Any job that falls between these two settings (if there is
a gap between the two) will be considered a Medium job.
l Small job max (pages): Enter the maximum number of pages a job can have and still be
considered Small.
l Large job max (pages): Enter the minimum number of pages a job must have before it is
considered to be a Large job.
Reserved engines group:
These settings allow you to reserve some Weaver (Output) engines for small and medium
Output Creation tasks. This it to prevent large jobs from using all available engines and
blocking small or medium jobs from running. Since Weaver engines cannot switch tasks, such
behaviour can only be achieved through reserving engines for small and/or medium jobs.
Engines may be reserved both for small, and for medium sized jobs. Engine reservations are
not required for either though.
l Small job (engines): Optionally enter the number of Weaver engines you wish to reserve
for Small jobs.
To make sure large batch jobs get sufficient speed during Output Creation, set a lower
Page 109