2022.1

l Left: Enter the distance between the left margin of the page and the Barcode, in
either metric (cm/mm), inch (in) or point (pt) values.
l Bottom: Enter the distance between the bottom margin of the page and the
Barcode, in either metric (cm/mm), inch (in) or point (pt) values.
l Codabar Properties group:
l Height: Enter the Barcode height in either metric (cm/mm), inch (in) or point (pt)
values.
l Module Width: Specifies the width of the narrow bars. Changing this value to a
higher value will generally make the Barcode bigger.
l Bar width ratio: Set the Barcode bar width.
l Default start symbol: Use the drop-down to select the optional Barcode start
character, which defines the encoding mode.
l Default stop symbol: Use the drop-down to select the Barcode stop character,
which defines the encoding mode.
l Print human readable text: Check to add a textual version of the Barcode
data.
l Placement: Use the drop-down to select whether to place the human
readable text above or below the Barcode.
l Font name: Use the drop-down to select the font with which to display the
human readable text.
Note
Vertically-oriented fonts (fonts whose typeface name begin with the at
(@) character) are not supported in Connect.
l Font size: Enter a font size for the human readable text.
l Display start/stop symbols checkbox: Adds the stop/start symbols to the
Barcode text.
l Process Tilde:
This selection is not applicable to this barcode type.
Page 1282