2022.1

l Start: Start number
l Stop: Stop number
l Condition: Enter the condition which determines whether or not the OMR Mark will
be added to the document at print time.
For details on how to create a conditional, see the "How to Set Conditionals" on the
facing page page.
l OMRMarks Tab:
l #: OMR Mark number (display only).
l Type: Type of OMR Mark (display only).
l Value: OMR Mark Value. These can be selected and altered for Sequence, Match
and Parity marks, as described below.
l
Add: Add an OMRMark entry to the table.
Choices are between:
l On: This represents a mark that is always printed.
l Off: This represents a mark that is never printed; i.e. it pads the marks out with
an empty position.
l Group Start: This represents a mark that is printed on the first page of a
group.
l Group End: This represents a mark that is printed on the last page of a group.
Note
In a single page group both Group Start and End marks will print if
defined since the page is both the start and end of the group.
l Sequence: This represents a mark that is printed when the specified bit is set
in the sequence number of the page.
For example, if the bit for the mark is set to 2 and the sequence number for the
page is 5 then it will not print since the value 5 consists of the bits 1 and 4.
Use the drop down box to select the entry.
l Match: This represents a mark that is printed when the specified bit is set in
the match number of the group.
For example, if the bit for the mark is set to 2 and the match number for the
Page 1313