2022.1

Note
If the Stack Depth is greater than the number of sheets in the entire job then
you will get a single drill sorted block that can be guillotined and stacked to
give the complete job in record order.
l Sides selection: Select how many sides of the Imposition Sheet are to be
printed upon. Choice is between Simplex or Duplex.
l Method selection: In 2018.2 we introduced a new imposition page order for
cut & stack impositioning that works with continuous feed devices:Stack by
Column. This option is intended for impositions with more than 1 row. It places
the next page in the next row of the same column on the current sheet, instead
of in the same row and column of the next sheet like the pre-existing Cut and
Stack does.
The choices are between:
l Cut and Stack:Any preset created in a version of Connect prior to
Connect 2018.2 will default to this Layout Method. It allows total control
of subsequent Page Order choices.
l Stack by Column: For use with continuous feed printers. This selection
limits subsequent Page Order choices to column based options only.
l Page Order: Select in which direction to go when adding sections to the
output:
l
Left to right, top to bottom
l
Right to left, top to bottom
l
Top to bottom, left to right
l
Top to bottom, right to left
l Reverse selection: The reverse selections have been extended in Connect
2018.2, with the addition of the Inverse page order option. The options now
available are:
Page 1323