2022.1

4. Use the saved file to expand the data mapping configuration (see "Opening a data
mapping configuration" on page227). Send the data mapping configuration to Workflow.
5. Send the Workflow configuration to the server.
Saving input as sample data
Testing a process in Debug mode is only possible with a sample data file. The process is pre-
configured to use the Sample Data.xml file located in the Configurations\Data folder.
To create your own sample data file:
1. Locate the Workflow configuration in the Configurations\Workflow folder and open it in
Connect Workflow.
2. Select the process.
3. Enable the Send to Folder step (step 2 in the process).
4. Send the Workflow configuration to PlanetPress Workflow service (see Saving and
sending a Workflow Configuration) and run it again, with a custom name value.
The Send to Folder step will now write the input data - the job file - to a file in the
Workspace\Debug folder.
When you select the file as sample file (on the Debug ribbon), it can be used to debug the
process.
Tip
The saved file can be used to create a data mapping configuration.
The report
Using different data in the report requires changing the COTG Timesheet Report template
(see "Personalizing content" on page830).
Tip
The Designer can have one data mapping configuration and one template open at the
same time. Use the tabs at the top of the workspace to switch between the two. Click the
synchronize button on the Data Model pane to make sure that the Data Models are the
Page 157