2022.1

Permissions for PlanetPress Connect Server
The PlanetPress Connect Server module, used by the Automation module, requires some
special permissions to run. These permissions are set during installation, in the Engine
Configuration portion of the "Installation Wizard" on page37, but it can also be configured later
by modifying permissions for the service. To do this:
l In Windows, open the Control Panel, Administrative Tools, then Services (this may
depend on your operating system).
l Locate the service called Serverengine_UUID , where UUID is a series of characters that
depend on the machine where the software is installed.
l Right-click on the service and select Properties.
l In the Connection tab, define the account name and password that the service should
use. This can be a local account on the computer or an account on a Windows Domain.
The account must have administrative access on the machine. It should also correspond
to the user account set up in PlanetPress Worfklow.
OL Connect Server user accounts
By default, authentication is enabled on the Connect Server. During a new installation the OL
Connect Server's default authentication must be configured by specifying a user name and
password. The default username for new installations is olc-user.
More user accounts can be configured in the Server Configuration Tool (see "Security and
Users Settings" on page92).
In any Connect Designer that uses a secured Connect Server, an authenticated user account
must be specified via the Designer's Preferences (see the "Connect Servers preferences" on
page914 sub-section of the Designer Preferences dialog).
Note that prior to PlanetPress Connect version 2020.2, only one user account could be
configured on a Connect Server. The default username was ol-admin and the default
password was secret.
Installing PlanetPress Connect on Machines without Internet Access
Installing PlanetPress Connect2022.1 in offline mode requires some extra steps. These are
listed below.
Page 35