7.5

Table Of Contents

moveto(1,1) %Reset current point

lineto(1.5,2) %Draw first line

lineto(0.5,2) %Draw second line

closepath() %Close shape

stroke() %Draw shape

Object $name()... EndObject (procedure)

Creates an object. You can reference the object you create using the $ operator. See "$element (procedure)" (page 613).

This command can only be used from within the PressTalk Before and PressTalk After of a PlanetPress Design doc-

ument, and cannot exist within a page's properties or the PressTalk of any object, including

Syntax

object $name( top, left, width, height, condition, angle[, setsnappingpoint[, snap-

toprevious]] )

%Object Contents

endobject()

Argument

$name (PressTalk Name)

Name to use for the object, preceded by the dollar sign character ($). The name must conform to the rules for names

described in "Names" (page 221).

top (Measure)

Measure value specifying the distance, in inches, to offset the top edge of the picture object, from the top edge of the doc-

ument page. If you set the snaptoprevious argument to a value other than 0, the value you set for the top argument becomes

the vertical offset for the Snap to previous snapping point.

left (Measure)

Measure value specifying the distance, in inches, to offset the left edge of the picture object, from the left edge of the doc-

ument page. If you set the snaptoprevious argument to a value other than 0, the value you set for the left argument becomes

the horizontal offset for the Snap to previous snapping point.

width, height (Measure)

Measure values specifying the width and height respectively, in inches, of the object.

condition (Boolean)

Boolean value, or PlanetPress Talk expression that resolves to a Boolean value, specifying a condition on the object.

angle (Measure)