2022.1

made.
You can even select how many pages are to be represented, whilst page numbers appear on
the pages in the diagram and change dynamically, like everything else.
It is important to note that if Impositioning is used then the only meta data that will be available
to the job thereafter will be the meta data at Job Segment level.
When using Impositioning everything within the Segment is Impositioned, so all meta data
below the Job Segment level is lost. If Booklet Binding were selected, some of the imposition
settings will be determined by the options made within the "Booklet Options" on page769 Page
and those imposition settings will thus be disabled on this page.
Note
During Impositioning, all hyperlinks - both external and internal - are removed from the
document (see "Hyperlink and mailto link" on page264).
The Imposition selections that can be made are as follows:
l Sample Page group: Use to choose a paper size for the logical page(s) which would be
printed upon the actual physical Imposition sheet. This helps in decision making
regarding what paper sizes and orientations to use, with the Sample Page shown in blue
on the white Imposition Sheet in the output preview (and validation) diagram.
Note
The logical page size can be set independently of any template open in the
Designer, allowing for output presets to be created independently from the active
template.
If a template is currently loaded in Connect Designer, the size and portrait attribute
of the first section of that template are used as defaults for the Sample Page.
As a general rule, it makes little sense to modify the Sample Page size within the
Page 771