Getting Started Guide
Table Of Contents
- Product Overview
- 2. Camera Indicator
- 3. Lens
- 4. Cooling Intake
- 5. Magnetic Charging Port
- 6. Power/Status Button
- 7. USB-C Data Port
- 8. Cooling Outlet
- 9. Microphone Jack
- 10. Micro SD Slot
- 11. M3 Nut Connection
- 12. Electrical Contact Interface
- Indicator Statuses
- Battery Indicator
- Camera Indicator
- The camera indicator has five statuses: Red indica
- Camera Indicator Status
- Description
- All 3 bars continuously flashing red indicates a w
- 3 bars on steady red indicate an exception alarm,
- All 3 bars continuously flashing yellow indicates
- All 3 bars on steady yellow indicates a notificati
- The middle bar on steady yellow indicates a notifi
- The middle bar on steady green indicates there is
- All 3 bars on steady green indicates there is a ta
- 1 green flash of all 3 bars indicates a photo was
- All 3 bars continuously flashing green indicates t
- 3 green flashes of all 3 bars indicates shooting u
- Blue flashes of 1, 1&2, and then 1&2&3 bars and th
- Continuous flashes of alternating green and yellow
- Obsbot Studio App
- How to Use Tail Auto-Director AI Camera
- Charging Instructions
- Startup & Shutdown
- Connecting to the App
- Gesture Control
- Target Selection
- Tail Auto-Director AI Camera allows you to select
- Gestures: After turning on the camera normally, m
- App Selection: On the app's shooting interface, ta
- •Quick Mode: Tap the "Quick" button to have the cam
- •Multi-Persor Mode: Tap the "Multi-Person" button t
- •Owner Mode: Tap the "Owner" button to have the cam
- Shooting Modes
- Specifications and Parameters
- Warning words
Warning words
This device complies with part 15 of the FCC Rules. Operation is subject to the condition that
this device does not cause harmful interference (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates and
can radiate radio frequency energy, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
FCC ID:2ASMC-OBS-TAIL-01
This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body.