Getting Started Guide
Table Of Contents
- Product Overview
- 2. Camera Indicator
- 3. Lens
- 4. Cooling Intake
- 5. Magnetic Charging Port
- 6. Power/Status Button
- 7. USB-C Data Port
- 8. Cooling Outlet
- 9. Microphone Jack
- 10. Micro SD Slot
- 11. M3 Nut Connection
- 12. Electrical Contact Interface
- Indicator Statuses
- Battery Indicator
- Camera Indicator
- The camera indicator has five statuses: Red indica
- Camera Indicator Status
- Description
- All 3 bars continuously flashing red indicates a w
- 3 bars on steady red indicate an exception alarm,
- All 3 bars continuously flashing yellow indicates
- All 3 bars on steady yellow indicates a notificati
- The middle bar on steady yellow indicates a notifi
- The middle bar on steady green indicates there is
- All 3 bars on steady green indicates there is a ta
- 1 green flash of all 3 bars indicates a photo was
- All 3 bars continuously flashing green indicates t
- 3 green flashes of all 3 bars indicates shooting u
- Blue flashes of 1, 1&2, and then 1&2&3 bars and th
- Continuous flashes of alternating green and yellow
- Obsbot Studio App
- How to Use Tail Auto-Director AI Camera
- Charging Instructions
- Startup & Shutdown
- Connecting to the App
- Gesture Control
- Target Selection
- Tail Auto-Director AI Camera allows you to select
- Gestures: After turning on the camera normally, m
- App Selection: On the app's shooting interface, ta
- •Quick Mode: Tap the "Quick" button to have the cam
- •Multi-Persor Mode: Tap the "Multi-Person" button t
- •Owner Mode: Tap the "Owner" button to have the cam
- Shooting Modes
- Specifications and Parameters
- Warning words
6
Remo All Rights Reserved
Press and hold the power button for 3 seconds to turn the
camera on or off.
Connecting to the App
1. When you turn on the Tail Auto-Director AI camera, the
device will run a self-check, while the camera indicator
slowly flashes yellow. After the self-check is completed, the
camera indicator will turn to steady green.
2. Enable the Wi-Fi function on your mobile device and run
the OBSBOT Studio App. Select the OBSBOT-XXX
network and enter the default password "12345678" to
connect.