Quick Guide

Table Of Contents

5 Startup

After you have installed the device, connect one end of the power adapter

(purchased separately) to power supply, and then connect the other end to the

power interface to start up the device.

6 Access Your Camera

1. Open your Web browser, enter the camera's IP address in the address bar, and

then press Enter. The default IP is 192.168.1.13.

2. In the login page, enter the default username and password (admin/123456),

then click Login.

NOTE!

 DHCP is enabled by default. If a DHCP server is used in your network, your

camera may be assigned an IP address, and you need to use the assigned IP

address to log in.

 You may need to install a plug-in at your first login. Please follow the on-screen

instructions to complete the installation and then open the browser again to

 The default password is intended only for your first login. To ensure security,

please change the password after your first login. You are strongly

recommended to set a strong password of at least nine characters including all

three elements: digits, letters and special characters.

 If the password has been changed, please use the new password to log in.