Operation Manual

Page 1-22
1-3 Using the Scanner Function
(8) Centering
(“Centering/Image shift mode”)
When the ratio for the length and width of the scan image does not fit, it may cause the margin being
enlarged. With this mode, you can center the image on the scanning image when this function is set to
“ON”. If this function is set to set to “ON” in the initial mode, all of the originals to be scanned will be
centered on scanning image.
* Factory default setting: OFF
* “Centering” setting is available by 45, 55 and 63 ppm machines.
• When the transmitting size that the ratio of the original size and length/width is different is
selected.
Centering “ON”
Scanning
area
Scanning
area
Scanning
area
Centering “OFF”