SKYSCREEN Roller Surface 2 Assembly, Tensioning & Installation Instructions Parts Diagram
Page 2 of 8 Assembly instructions Unpack SKYSCREEN using suitable implement to avoid damaging contents and lay SKYSCREEN out as shown. A B Contents: A. Blind/Fly Cassettes - 2 off B. Side Rail - 2 off Lay cassette and side rail face down as shown. Line up and slot corner radius into side rail. Continue to slot side rail onto corner moulding. Lift crossbar and continue to slot side rail. Click !! Ensure side rail slots on inside of corner moulding lip. Repeat steps above for other corners.
Page 3 of 8 Tensioning the Blind or Fly The SKYSCREEN Is assembled and tested before shipping and does not need tensioning. However if tensioning is lost for any reason, please follow the steps below. With the screen facing you, the tension adjustment is located under the right hand top screw cover Remove screw cover and turn the SKYSCREEN over. SPRING TENSION SPRING TENSION Turn clockwise to tension or anti-clockwise to de-tension. NOTE: No more than 8 full turns should be required.
Page 4 of 8 Installing the SKYSCREEN Before installation • • • • • Measure the SKYSCREEN and make sure it is the correct size. Make sure the unit is fitted to a flat surface to avoid forcing the unit out of shape when fixing. If SKYSCREEN is large; ensure a minimum of two people undertake the installation. Ensure that the SKYSCREEN is the correct way up and in the desired orientation. Make sure that the SKYSCREEN is not twisted; distortion will damage the blind and affect operation.
Page 5 of 8 SKYSCREEN Roller Surface Mk3 Parts Diagram 5 4 6 3 7 2 8 1 21 20 9 10 19 11 18 12 17 16 15 14 13 Spare Part Kits Blind assembly Oceanair Kit Part No.
