Installation Guide

Page 4 of 8
1
2
x 4
Open screw covers as shown.
Insert and tighten screws in each corner using
screwdriver, do not use electric screwdriver.
Note:
If the screen is to be tted on to a soft headlining, we
recommend the use of M4 plastic washers (not supplied) to
shim between the screen and headlining. This will help to
avoid distortion of the frame and over compressing the
headlining material.
1
2
x 4
3
Installing the SKYSCREEN
Turn over and remove protective covers from adhesive
pads in each corner.
Ensuring mounting surfaces are free form dust or grease,
use the adhesive pads to hold the SKYCREEN in position
and drill pilot holes. Ensure that the thickness of the boat
structure at the proposed mounting position is deep enough
to prevent the xing screws from breaking through. Oceanair
recommend No6 x 16mm [5/8”] PANHEAD Screws (not
provided). However if necessary, use shorter xing screws and
use masking tape on the drill bit as a depth guide to avoid
drilling too deep.
x 4
1
2
x 4
4
1
2
5
Close screw covers.
6
Check operation of SKYSCREEN.
Before installation
• Measure the SKYSCREEN and make sure it is the correct size.
• Make sure the unit is tted to a at surface to avoid forcing the unit out of shape when xing.
• If SKYSCREEN is large; ensure a minimum of two people undertake the installation.
• Ensure that the SKYSCREEN is the correct way up and in the desired orientation.
• Make sure that the SKYSCREEN is not twisted; distortion will damage the blind and affect operation.