Owner's manual
Note: When one of the above malfunctions occurs, turn off the unit
and check for any obstructions. Restart the Unit. If the malfunction
persists, turn off the unit and unplug the power cord. Contact the
manufacturer or its service agents or a similarly qualified person for
service.
and read P1 on the LED display (it will stay like this until the unit is drained). If
this happens, you should drain the water from the lower drain (located at the
bottom of the unit).
- Press the "MODE" button until the "COOL" indicator light comes on.
- Press the Up (+) and Down (-) buttons to select your desired room temperature.
The temperature can be set within a range of 17°C~30°C/62°F~86°F.
- Press the "FAN" button to choose the fan speed.
- Press the "MODE" button until the "DRY" indicator light comes on.
- Under this mode, you cannot select a fan speed or adjust the temperature. The fan
motor operates at LOW speed.
- Keep windows and doors closed for the best dehumidifying effect.
- Do not connect the exhaust hose to a window.
- In cool mode, this unit is made to self-evaporate. This means if you keep the rubber
stoppers closed on the back of the unit, the water will evaporate and you will not
have to drain.
- In cases of extreme humidity, you may have some water accumulation that the unit
is unable to evaporate. In this case, the unit will beep 8 times, switch to fan mode,
- This feature can be activated from the remote control ONLY.
- When you set the air conditioner in AUTO mode, it will automatically select cooling or
fan only operation depending on what temperature you have selected and the current
room temperature.
- The air conditioner will control room temperature automatically according to the
temperature point set by you.
- Under AUTO mode, you cannot select the fan speed.
- Press the "MODE" button until the "FAN" indicator light comes on.
- Press the "FAN" button to choose the fan speed. The temperature cannot be adjusted.
-
Do not connect the exhaust hose to a window.
- In COOL or DRY mode, press the "MODE" button for 3 seconds to turn on or off the
constant fan function. When the function is turned on, the constant fan light will illuminate,
identifying that the fan will continuously run for cooling.
AUTO operation
Constant Fan operation