User's Manual

12
Alarm Volume – Adjust the volume of the alarm as you like by rotating the dial.
4. After the above settings are completed, press the left  button to exit and make sure the
Alarm is turned on. You will see the Alarm icon appeared on the display if it is activated.
Snooze
The alarm sounds every 9 minutes when the snooze button is pressed. Press “Standby” key to
cancel Snooze function
Sleep Timer Setting
You can set the timer to let the radio go standby after certain time elapsed in the range of 15
minutes to 180 minutes.
You can press <Sleep> button on the remote controller to set the timer.
You will see the icon appeared on the display if the timer is set.
Configuration
Network
There are two options under this setting: Wi-Fi Network and Wi-Fi Channels
Wi-Fi Network
 Add / Remove AP
Add AP – It will scan out a list of routers available nearby
Remove AP – If you have already added a router and want to remove it, choose this option.
 AP: [ ]
If you have added more than one routers on the radio and want to switch to another one,
select this option to change.
 Signal
This is to show the strength of the Wi-Fi Signal of the Wi-Fi router as received by the radio.
Usually signal levels lower than -70dBm is at weaker level and if it affects the reception of
your radio, you may need to optimize the router location or check any problem of the router
itself.
 IP
The IP is set <Dynamic> by default. Select to change <Fixed> IP according to your network
condition.
 DNS
The DNS is set <Dynamic> by default. Select to change <Fixed> DNS according to your
network condition.
Wi-Fi Channels
Not all of the Wi-Fi channels are available in every country. There may be variation
Alarm Sleep Timer
1. fm Bay Smooth Jazz
H2 ch
<
18/11225 00:25
iRadio