5 Speaker -iQS™ 3D Surround with Bluetooth wireless MODEL Zeno 1 - 15
CONTENTS 1. Contents ................................................................................................. 1 2. Getting Started .................................................................................... 2 3. Safety Instructions............................................................................... 3-4 4. Remote-Control-Buttons and functions…...................................... 5 5. Front and Back Panel- Control and Function .................................... 6-7 6.
GETTING STARTED Before attempting to connect, operate or adjust this product, please read these instructions carefully, and keep this manual for future reference Description: The Zeno is a compact table top 3.1 speaker system with wireless Bluetooth connectivity and SoniQ iQS TM surround processing.
SAFETY INFORMATION SPECIFICATIONS Power Adaptor 100-240V 50/60 Hz Audio Power 85 W of music power 30 W Internal Subwoofer Inputs Wireless Bluetooth 1x3.
SAFETY INFORMATION OPERATING INSTRUCTIONS 3. Do not install the equipment in a dusty, damp or poorly ventilated place. 1) Sound Stage Settings The settings are selected using the remote and is indicated the iQS 3D LED#2. a) If the selected setting is MOVIE mode, the LED color is Yellow. This creates wide sound stage which is ideal for action movies. 4. To prevent damage to the equipment, please unplug from the power outlet if not in use. 5.
OPERATING INSTRUCTIONS REMOTE CONTROL - CONTROLS AND FUNCTIONS Charging mobile phone The USB connector on the rear of the speaker is only for charging battery of Mobile phone. Mute Power It will not play audio from any audio device. Plug in the USB cable into the USB connector, and the mobile phone / device will start charging. BT Power saving mode Music If the music is stopped on S550 and remain for 30 minutes with no music playing, the S550will automatically go into Standby mode to save power.
FRONT & BACK PANEL CONTROLS AND FUNCTIONS 1. Speaker 2. LED indicator 3. Standby 4. Pairing 5. Volume – 6. Volume + 7. Speaker 8. Remote sensor 9. Speaker 10. Power ON/OFF 11. AUX -IN 12. DC Socket 13. USB Socket for charging Mobile 14. Speaker 15. Sub Woofer OPERATING INSTRUCTIONS To pair additional devices With the Bluetooth device and the Zeno speaker both turned On, press the PAIR button once to disconnect your paired Bluetooth device.
OPERATING INSTRUCTIONS FRONTAND BACK PANEL - CONTROLS AND FUNCTIONS To Begin pairing with a Bluetooth device 1. Switch on the Power button, LED #1 indicator will be in Red, then press the STBY button to power On the Zeno. The LED will change to Blue. 2. Hold and press the “PAIR” button on the unit until the LED #3 starts flashing in Blue. You will hear a beeping tone. It is now ready for Bluetooth connection. 3. Make sure your Bluetooth device has the Bluetooth enabled.
HOW AND WHEN TO CHANGE BATTERIES OPERATING INSTRUCTIONS A. Connecting to AC power 1. Insert Batteries: Insert one CR2025 Lithium button cell battery into the battery compartment. Make sure the battery is inserted with the “+” side facing down. Notice: Do not throw the remote control down on the ground or tread on it. Remove the battery from the remote control when it’s not in use for an extended period or during Shipment. 2.
FCC WARNING This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
