User's Manual

SafeSea V100 User Manual

10 Version 0A.00 21/07/2011

Note: if there are no channels already entered, pressing this key will have no effect.

To exit the Memory Scan mode, press the SCAN or ▼ key.

Scan advance

In any of the scanning modes, pressing the ▲ key will advance the scan

on one channel.

Setting Scan Channels

In the normal radio mode, it is possible to set scanning options for each

channel.

To enter channels into the scan memory, select the required channel and

double press the SCAN key. The legend will appear on the LCD to

indicate this channel is in the scan memory.

If the channel was already marked as a Memory Scan channel, this

operation will remove it from the scan memory and the legend will

disappear.

To inhibit a channel from the all scan memory, press and hold the SCAN

key until a triple beep is heard. This will inhibit the channel from scanning

and the legend will appear on the LCD

If the channel was already inhibited as a scan channel, this operation will

enable it again and the legend will disappear.

In the menu mode the following options are available:- Memory Scan

Enable, All Scan Inhibit, Key Lock, Key Beep Disable, Scan Dwell Time,

Light Dwell Time, Squelch Override Defeat, Squelch Override Time, Calling

Channel Select, Last Used Channel Enable, Serial number, Software Issue.

To enter the Menu Mode, press and hold the VOL key until a double beep

is heard.

Press the Enter key (Sq) to select the available options.

Once in the Menu mode, use the ▲ or ▼ keys to scroll through the

options listed above. The menu option will be displayed in the additional

area of the LCD screen.

When the desired option is selected, press the SQ key to adjust the

setting or value, shown in the channel number.

Use the ▲ or ▼ keys to adjust the value.

Press the SQ key to enter the new value.

Press the 16 key or press and hold the VOL key to exit Menu mode.