Owners Manual

INSTALLATION INSTRUCTIONS

RECEIVING—INSPECTION

Upon receiving your 2OAC unit, inspect the packaging for any damage. All units are

shipped on a skid, and packaged in a triple-wall carton for added protection.

BEFORE INSTALLING

Check the unit for any damage. All OceanAire products are thoroughly inspected at the

factory and carefully packaged. If any damage is evident, contact OceanAire

IMMEDIATELY.

ELECTRICAL REQUIREMENTS

Check the nameplate located on the back of the unit to confirm the proper power is

available for the unit. Refer to "Specifications" section for voltage and amperage

requirements. For proper NEMA receptacles, refer to "Electrical service plug

configuration". When using extension cords, use the proper gauge cord, and check cord

voltage to the unit.

TIME DELAY FUSES/CIRCUIT BREAKERS ARE RECOMMENDED

WARNING—OPERATING THE UNIT ON IMPROPER

VOLTAGE WILL VOID THE WARRANTY

ACCESSORIES

Verify that all accessories are correct for the model, and are installed in accordance with

all instructions.

START-UP

Install the unit in accordance with all local and state building codes, and install all

accessories. Allow for a clearance around the unit for future maintenance and/or service.

Level unit and lock casters, when available. Connect power and test the LCDI on the

power cord (if available). Power up unit, via thermostat and check for proper operation.

Refer to Thermostat Operation for more details.