Engineering, Installation and Service Manual

USE OF EXTENSION CORDS

CAUTION:

FOR MODEL PAC1211 AN EXTENSION CORD CAN BE USED PROVIDED IT IS

RATED AT LEAST 15 AMPS @ 115 VOLTS WITH GROUNDING-TYPE ATTACH-

MENT PLUG AND GROUNDING TYPE CONNECTOR (LOAD FITTING)

FOR MODEL PAC1811

AN EXTENSION CORD CAN BE USED PROVIDED IT IS

RATED AT LEAST 20 AMPS @ 115 VOLTS WITH GROUNDING-TYPE ATTACH-

MENT PLUG AND GROUNDING TYPE CONNECTOR (LOAD FITTING)

FOR MODEL PAC2412

AN EXTENSION CORD CAN BE USED PROVIDED IT IS

RATED AT LEAST 20 AMPS @ 250 VOLTS WITH GROUNDING-TYPE ATTACH-

MENT PLUG AND GROUNDING TYPE CONNECTOR (LOAD FITTING)

FOR MODEL PAC3612

AN EXTENSION CORD CAN BE USED PROVIDED IT IS

RATED AT LEAST 30 AMPS @ 250 VOLTS WITH GROUNDING-TYPE ATTACH-

MENT PLUG AND GROUNDING TYPE CONNECTOR (LOAD FITTING)

FOR MODEL PAC6012

AN EXTENSION CORD CAN BE USED PROVIDED IT IS

RATED AT LEAST 50 AMPS @ 250 VOLTS WITH GROUNDING-TYPE ATTACH-

MENT PLUG AND GROUNDING TYPE CONNECTOR (LOAD FITTING)

FOR MODELS PAC3632 AND PAC6032

AN EXTENSION CORD MAY BEUSED

PROVIDED IT IS RATED AT LEAST 30 AMPS @ 250 VOLTS, 3 PHASE

FOR MODELS PAC3634 AND PAC6034

AN EXTENSION CORD CAN BE USED

PROVIDED IT IS RATED AT LEAST 20 AMPS @ 600 VOLTS, 3 PHASE

SPECIAL NOTICE—THREE PHASE OPERATION

Models PAC3632, PAC3634, PAC6032 and PAC6034

All three-phase CONVERTIBLEAIRE models are equipped with a

three-phase monitor for added compressor protection. The phase

monitor, located in the control box, has multi-color LED that reports

status. The monitor protects the compressor from reverse operation,

phase loss and low voltage situations. Further description of the

three-phase monitor is located in the electrical section of the manual.

NOTICE - DO NOT OPERATE ANY THREE-PHASE UNIT BY BY-

PASSING THE MONITOR, THIS WILL VOID THE WARRANTY