Operation Manual

MAKING THE DATATRANS PLUS PERSONAL

Before you dive with the DataTrans Plus for the first time, you will need to be-

come acquainted with its interactive features, and select your personal display

settings using the Control Console and Mode Menu.

The transmitter must first be installed into a high pressure port of your regu-

lator first stage, facing to one side (Fig. 24) - unless you purchased the DX3

™

Integrated first stage in which the transmitter is a built-in component (Fig.

25). Oceanic strongly recommends that installation be performed by an Au-

thorized Oceanic Dealer at the time of purchase. If this is not possible, refer to

the instructions for this procedure on page 102.

NOTE: The DataTrans Plus transmitter is compatible with all

Oceanic first stages, but cannot be guaranteed to fit certain

models produced by other manufacturers. Check with your Au-

thorized Oceanic Dealer to verify compatibility with your regu-

lator first stage.

For the Display Module to receive a tank pressure signal from the Transmit-

ter, the two devices must first be 'Linked'. The code (serial number) of the

Transmitter must be entered as the 'Link' code in the Display Module.

Fig. 25 - DX3 Integrated

First Stage

Fig. 24 - Standard

First Stage