Operation Manual

DataTrans Plus

If your Display Module and Transmitter were packaged and shipped from the

factory as a complete system, the code of your Transmitter has already been

entered as the 'Link' code in your Display Module. If the two units have been

purchased separately by you or your Authorized Oceanic Dealer, it will be nec-

essary to set the Link code in the Display Module so that a tank pressure sig-

nal can be received. If the Display Module has been purchased as a stand

alone computer without the Transmitter, it has been preset at the factory as a

non-linked unit, but can easily be reset at any time to 'Link' with a Transmit-

ter code (serial number) using the Control Console.

ACTIVATING THE DISPLAY

Before activating the Display Module, the regulator containing the transmitter

must be connected to a full tank and pressurized by slowly opening the tank

valve. Tank pressure of 50 psi (3.5 BAR ), or greater, is required for the trans-

mitter to activate. Position the display module within 3 feet (1 m) of and par-

allel to the transmitter (Fig. 26), and hold it in this location during activation.

WARNING: Never activate the DataTrans Plus underwater.

This may result in inaccurate depth and no-decompression time

displays. If activated deeper than 4 feet (1 meter) underwater a

message "TOO DEEP" will appear and the unit will shut off.

Fig. 26 - Positioning

During Activation

DECO

C.Z. C.Z.

PSI

BAR

NO DECO

MAX