Operation Manual

Low Battery conditions and battery power conservation are described in more

detail in the Care & Maintenance section.

WARNING: If either or both of the Low Battery icons remain

on display following diagnostics, Oceanic strongly recommends

that you DO NOT dive until the batteries are replaced. See the

battery replacement procedure on page 99.

If no dive is made within 2 hours after initial activation, the Display Module

will automatically deactivate to conserve its battery power. Check your Dis-

play Module before entering the water to verify that it is functioning and

doesn’t need reactivation.

To save its battery power while on the surface, the Display Module will stop

searching for a Transmitter signal after 10 minutes. The signal Link can be

restored by depressing the Select/Right button on the Display Module. It will

also be restored automatically upon descent on a dive.

WARNING: During activation and diagnostics, if any display or

message varies from the information presented here, return the

DataTrans Plus to your Oceanic Dealer for inspection.

Be a -

RESPONSIBLE DIVER

at all times.