Operation Manual

DataTrans Plus

After the Alarm values have been set, SET:LINK will appear with LINK flash-

ing. To set the Transmitter Link code continue with step 4 of the following

LINKING procedure, or to return to the Surface Mode press the Advance/Left

button 2 times.

LINKING PROCEDURE

Your DataTrans Plus Display Module has been factory set with the

Transmitter's serial number, or at serial number 999999 if no Transmitter was

purchased. If the DataTrans Plus linked automatically immediately following

activation, there is no need to perform the Linking procedure. However, if the

Link icon and pressure value of 00 PSI remained flashing on the screen, the

Linking procedure must be performed before the Display Module can receive

tank pressure data from the Transmitter.

The Linking procedure may also need to be performed in the event that your

DataTrans Plus Display Module or Transmitter has received factory service,

and is returned to you with a different Linking code. You may also choose to

“unlink” your Display Module from the Transmitter to use the Display Module

as a stand alone computer, without its pressure integrated features, or to link

it to a Transmitter that has been purchased separately at a time in the future.

To set the Display Module with the link code (serial number of the Transmit-

ter), follow this procedure beginning with step 1 if in the Surface Mode, or be-