Operation Manual

58
OC1 OPERATING MANUAL
© 2002 Design, 2009 Doc. No. 12-2761-r04 (9/6/11)
UPLOADING SETTINGS AND DOWNLOADING DATA
The Settings Upload portion of the Oceanlog PC Interface program can be used to set/change the OC1’s Main Time, Date, Set A
group (Alarms), and Set U group (Utilities) using the same Interface System. The Set F group (FO2) and FREE Mode Alarms must
be entered using the OC1's button controls.
Information available for retrieval (download) from the OC1 to the Download portion of the program includes dive number, SI,
max depth, EDT, start date/time, lowest temperature, sampling rate, dive profile, OC1's Set Points, pressure, ATR, O2BG, TLBG,
and Gas Switching events/pressures.
Prior to attempting to download data from your OC1 or upload Settings to it, review the Help section of the interface program.
Recommended is to print those sections of Help that you consider appropriate for your Interface activities.
A USB Driver is provided on the Oceanlog CD as part of the Interface System.
The OC1 is configured with a Data Port located on the side (Fig. 158a) that enables it to be connected to a PC through a USB
port using the special Interface Cable supplied.
To connect the PCI Cable to the OC1:
> position the connector with the red dot at 12 o'clock.
> align the pins of the cable connector with the holes in the data port and press the connector into the port (Fig. 159A).
> turn the connector clockwise until the red dot is at 1 o'clock and it locks in (Fig. 159B), then release it.
The OC1 checks for a connection to the Data Port once every second while the Watch Default Time is displayed. Checks are not
made if the Wet Activation contacts are wet.
When the PC Interface cable is plugged in, the graphic PC COMM is displayed with a 2 minute countdown timer that runs until
the connection is confirmed, then the graphics PC COMM CONNECTED are displayed until completion of the upload or down-
load operation.
PC requirements:
• IBM
®
, or compatible, Personal Computer with USB Port
• Intel
®
Pentium 200 MHz or better microprocessor
• Microsoft
®
Windows
®
2000, XP, Vista, or 7
• Super VGA card or compatible video graphics adaptor (256 color or greater) with a minimum 800 X 600 pixel screen area
of display settings
• 16MB of available RAM
• 20MB of available hard drive storage
• Mouse
• CD Rom drive
• Printer
For software updates, refer to the Oceanic web site at -
www.OceanicWorldwide.com
For support, call OceanLog Support toll free at -
[phone], 8 Am to 5 Pm USA Pacific time.
Fig. 158 - OC1 DATA PORT
a
Fig. 159B - PCI CABLE
(turn dot to 1 o'clock)
Fig. 159A - PCI CABLE
(insert with dot at 12 o'clock)
dot
dot
TIMER
(counting down)
PCI CABLE
(connection sensed)