Operation Manual

PRESSURE TRANSMITTER

Before you dive with the VT Pro, you will need to become familiar with the interactive

features and select desired settings. The Transmitter must be installed into the High Pressure

port of your Regulator First Stage, facing to one side (Fig. 14). Oceanic strongly recom-

mends that installation be performed by an Authorized Oceanic Dealer at the time of

purchase. Instructions are provided on Page 92.

NOTE: The Transmitter is compatible with all Oceanic First Stages, but cannot

be guaranteed to fit certain models produced by other manufacturers. Check

with your Authorized Oceanic Dealer to verify compatibility with your Regula-

tor First Stage.

For the Display Module to receive a Tank Pressure signal from the Transmitter, the 2 devices

must first be Linked. The Serial Number (code) of the Transmitter must be entered as the

Link Code in the Display Module.

The Link Code is preset when shipped from the factory. To verify

the Code, refer to Page 43.

ACTIVATION

Before activating the Display Module, the regulator containing

the Transmitter must be connected to a Tank and pressurized by

slowly opening the Tank Valve. Tank Pressure of 50 PSI (3 BAR)

is required for the Transmitter to activate and send a signal.

Fig. 14 - Transmitter

mounted on First Stage