Operation Manual

Setting Digital Gauge Mode (continued) -

• Press and release the Side (Select) button to toggle between

ON and OFF.

• Press the Front (Advance) button to accept the setting and

advance to Set Water Activation, or press and hold Both

buttons for 2 seconds to revert to Surface Mode.

TO SET - WATER ACTIVATION (while in Surface Mode)

Factory set for ON, the Water Activation feature can also be set

for OFF (disabled) to prevent inadvertent activation during travel

or storage. When set ON, the VT Pro will automatically Activate

when immersed in water.

• Press Both buttons simultaneously, release when SET: 2

appears (4 seconds).

• Press and release the Front (Advance) button, the Units screen

appears with the set point flashing.

• Press the Front (Advance) button 18 more times

(17 more times after a dive in Digital Gauge Mode).

• The graphics ACT and H20 appear with ON (or OFF)

flashing (Fig. 47).

• Press and release the Side (Select) button to toggle between

ON and OFF.

• Press the Front (Advance) button to accept the setting and

revert to Surface Mode.

Fig. 47 - Set Water Activation

ATR

WARNING: If

this feature is

set for OFF, the

VT Pro must be

manually

activated prior

to commencing

a dive.