Operation Manual

Fig. 48 - Set Link Code OFF

TO SET -LINK CODE (while in Surface Mode)

Factory set for ON and the Serial Number of the Transmitter

shipped with the Display Module, the 6 digit Code can be set for

OFF or numbers ranging from 000000 to 999999.

When set OFF, the Display Module's receiver is disabled and no

displays or calculations relating to Pressure are provided.

• Press Both buttons simultaneously, release when SET: 2

appears (4 seconds).

• Press and release the Front (Advance) button, the Units screen

appears with the set point flashing.

• Press the Front (Advance) button 19 more times

(18 more times after a dive in Digital Gauge Mode).

• The graphics tid and ON (or OFF) appear with On (or OFF)

flashing.

• Press and release the Side (Select) button to toggle between

ON and OFF.

• Press the Front (Advance) button to accept the setting. If OFF

is selected (Fig. 48), operation reverts to Surface Mode. If

ON is selected, the First digit of the Code begins to flash (Fig.

49).

• Press and release the Side (Select) button to change the First

digit.

• Press the Front (Advance) button to accept the First digit. The

Second digit begins to flash.

ATR

Fig. 49 - Set Link Code ON

ATR