User Manual

Operators Guide

3. Carefully pull the battery out of its compartment as far as the wiring will allow.

4. Pull the connector off the terminals of the old battery and push it onto the terminals of

the new battery. For longer battery life it is recommended that you use a 9 V lithium

battery. However, a standard 9 V battery can also be used.

5. Replace the battery in its compartment, making sure that the wiring is not twisted or

pinched.

6. Replace the battery cover and tighten the three slotted screws.

7. Press the display actuator button and verify that the digital display and bubble level are

lit for approximately 15 seconds.

Balance mechanism calibration

The digital display indicates the setting of the balance mechanism on a scale of 0 (minimum

setting) to 182 (maximum setting). In the unlikely event of this system requiring calibration,

proceed as follows:

1. Level the platform and engage the tilt lock pin.

2. Press and hold the Display Actuator button for 20 seconds to enable calibration mode.

Figure 5 Battery replacement

Battery compartment

cover

9V PP3 battery

slotted screws