User Manual- C2560

Maintenance

Adjust Lock Levers

If the pan and/or tilt friction locks do not fully engage at the end of the

lock lever travel, adjust the lever position as follows:

1. Rotate the lock lever to the “locked” position.

2. The lock lever is attached by means of a screw. Carefully peel off

the lock label to expose the screw. Using a 2.5 mm Allen key

remove the screw.

3. Pull the lock lever off the hexagonal shaft, rotate it approx. 30°

away from the “locked” end of travel, and reinstall it.

4. Tighten the screw. Reapply the lock label.

1 Shaft

2 Tilt lock lever

3 Screw

4 Lock label

30°