User's Manual

(i) Peak Power: The Peak power varies from 0 to 100. It can be controlled to show the

higher peak points on the display in Data View. There is a color pattern for each peak

power range where colors on the red spectrum represent higher power, and on the

violet spectrum represent lower power. This field depends on the power threshold filter

entered below.

(ii) Power Threshold Filter: The Power Threshold filter varies from 0 to 10. This filters

below the specific threshold in dB entered in the textbox. Example: If the power

threshold filter is entered as 5, the targets below 5dB are filtered. Default

recommended is 0-1dB.

(iii) Height Limit: Used to filter out height information beyond a certain height, the limit

of which is set here.

(iv) Radar Height: For correct visualization of the 3D point cloud information, the

correct height of the radar from the ground would be required. The grid in the 3D

display is the actual ground, and the point cloud information is displayed from that

reference.

vi) Radar Sensors Select:

There are two checkboxes in the field which is chosen for the Front Sensor (Single

Sensor) and 360-degree (Multi Sensor) views.

Front Sensor View Checked: Radar 1 is automatically checked and only the first radar

will display data on the Data View tab.

360 Degree View Checked: All the radars are automatically checked, and they all display

data on the Data View tab.