Installation Guide

20 21
Whilemaintainingabovepositions:
• Pre-drill holes using the 3/32” bit.
• Insert 3” housing screws into top and bottom housing end caps.
Both screws should extend into the exterior trim.
5
5
Install Screen Housing
Instale el montante de la malla
If Long/Extended Sill
Position so housing
rests on top of sill.
On top of sill
Trim
Sill
Housing
Trim
Sill
Housing
Level with bottom
of sill face
If Short/Flush Sill
Position so housing is level
with bottom of sill face.
2
On hinge side of door; align housing to exterior trim.
1
Housing must be square to sill. Use a square to ensure that this is true.
3
Position so housing has at least 1” of overlap on trim.
4
Have a second person assist in holding the housing to ensure proper
alignment.
TIP
OR
Housing
1” Overlap
Top view of
housing position
(4) 3” Housing Screws /
(4) Tornillos de 3” para el montante
3/32” Bit / Broca de 3/32”
Drill / Taladro
Phillips Drill Bit / Broca Phillips
(2) Screen Housings /
(2) Montantes de las mallas
Square / Escuadra
TOOLS & PARTS
5
5
1
4
2
3
Si la solera es larga o extendida
Coloque la solera para que el
montante se apoye sobre la parte
superior de la solera.
Si la solera es corta o al ras
Coloque la solera para que el
montante esté nivelado con
la parte inferior del frente de
la solera.
2
Del lado de la bisagra de la puerta, alinee el montante con el
borde exterior.
1
Cuente con la ayuda de otra persona que sostenga el montante para
garantizar el alineamiento correcto.
CONSEJO
OR
El montante debe estar encuadrado con la solera. Utilice la escuadra
para asegurarse de que sea así.
3
Coloque el montante de manera que pase al menos 1” (2,5 cm)
del borde.
4
Con las posiciones arriba mencionadas:
• Perfore con anterioridad los orificios con una broca de 3/32”.
• Insertelostornillosde3”paraelmontanteenlastapasparalos
extremos de los montantes superior e inferior.
Ambos tornillos deben extenderse hasta el borde exterior.
5