Owner manual

INSTALLATION INSTRUCTIONS
for Doors with Integral Nailing Fin (JII006-ODL)
4
b. Adhere the
pieces of
ashing to the
inside corners.
5. Smoothgapsor
bubbles beneath
self-adhesive
ashing with a
J-roller (remove
and replace if
necessary).
INSTALL SILL PAN
1. Place the sill pan in
the rough opening.
2. Apply spray
adhesive/primer to
the sill area. Follow
manufacturer's
instructions
for application
methods.
3.Cutapieceofself-
adhesive ashing
the length of the sill
and apply over the
sill pan as shown.
The bottom of the
sill pan should be
completely covered
by the self-adhesive
ashing.
6. Seal back corners
of sill pan with
sealant.
7. For step-down
landings only, cut
plastic drain screen
to length of
sill + 2" and staple
1/2" below sill
edge. The drain
screen provides
a path for air to
dry any incidental
moisture in the
rough opening.
8. For continuous
slab landings only,
remove nailing n at sill.
9. Applya3/8"continuousbeadofsealantacrossthesillpanback
dam.
10. Tilt patio door into the rough opening. Make sure the back of the
door makes solid contact with the sealant. Adequately support the
door until fully installed.
S
p
r
a
y
A
d
h
e
s
i
v
e
6"
3"
4. Cuttwopieces
of self-adhesive
ashing 6" wide
and the sill pan
width+3"long.
a. For continuous
slab landings
only, cut out the
inside corner.
Sill
pan
width
6"
3"
Discard
(for
continuous
slab only)
Self-Sealing Corner Flash
Sill
pan
width
3"
6"
Discard
(for
continuous
slab only)
Sill pan
width
3"
3"
Continuous Slab Landing
Sill pan
width
3"
3"
Step-Down Landing
Sill pan
width
3"
3"
Sealant
1"
1/2"
4
PREPARE ROUGH OPENING - CONTINUED