Operation Manual

37
5. Enable the item “Data Enabled” if it is not yet ticked.
6. Select item “Access Point Names” to add an Internet access
point.
7. Press the menu button and select “New APN”.
Note:
The list stays empty if no APN is entered or the connected dongle
was not detected
8. Enter the access data obtained from your mobile service
provider.
Contact your mobile service provider to obtain all required
access data, if necessary.
9. Press the Return button to save the settings.
10. The list of set APNs is displayed. After setup generally only
one value is listed.
11. Ensure that the item on the right of your entered APN is
green; otherwise tap on it to activate.
12. Exit the settings and access a website with the browsers.
13. Observe the dongle status LED. It generally (depending on
model) turns blue after successful connection. The LED
flashes blue if the connection to the provider is established,
but no data are transmitted yet.
Caution!
The connection is available if it is displayed.
Re-start the device if it is not displayed.
The letters at the connection icon show the current connection
speed.
H = HSDPA (highest speed)
3G = UMTS
E = EDGE
G = GPRS (lowest speed)
Contact our customer support at [e-mail] if you require
help.