User Guide
• Install the rocker switch to the handlebar using the hardware included in this kit as shown below.
• It is recommended that the switch be installed on the left handlebar. Exact position may vary depending on vehicle.
• Use a piece of electrical tape (not provided) around the handlebar to help prevent rotation of the switch bracket mount.
• Tighten the rocker switch in place. DO NOT overtighten or tighten/clamp over any hose, wiring or cables.
• Once the rocker switch is mounted, the wires can be routed to the contactor/solenoid location.
• Make sure the handlebars have full range of motion, vehicle switches/brakes/throttle can move freely, and then secure the rocker
switch’s cable with the supplied cable ties.
• Using the provided wire splice, splice the end of the red 20ga wire to a key controlled, fused, accessory circuit (power point) of the
ATV/UTV. The wire should only have power when the key is in the “ON” position.
• The contactor/solenoid is a primary safety feature in the winch system. It disconnects the winch from its power source when the
vehicle is not in use. The contactor/solenoid must be correctly installed to work properly.
• Find a location for the contactor/solenoid. It is recommended that the contactor/solenoid be mounted close to the battery in a clean,
dry location. The exact location of the contactor/solenoid will vary depending on the vehicle. Make sure the location chosen allows
for sufficient clearance from all metal components such as frame tubes. DO NOT place tools or other items in a position that might
come in contact with the contactor/solenoid posts.
• Drill mounting holes if required. Secure the contactor/solenoid using the provided hardware.
• Once a location is found for the contactor/solenoid, DO NOT install the unit until all wiring is completed (see wiring section). Pre-fit
all wiring to confirm its long enough to reach the battery and the winch contact locations.
short batteryterminals with metal objects. Be
aware terminals in contact with metal will cause a
direct short, possibly causing contactor/ solenoid
5
INSTRUVTION ATV-S型.indd 6 2018/12/28 星期五 14:49:30
3000-4500lbs-S型-新.indd 6 2019/1/2 23:00:49
未命名-7 5 2020/5/21 星期四 16:59:23
未命名-1 5 2020/5/22 星期五 7:33:23
未命名-1 5 2020/5/22 星期五 7:36:59