User Manual

Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Model 811-LX Avenger Series Executive Mid-Back Chair
WEIGHT CAPACITY: 500 lbs.
Parts Listing
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919-303-6389 (voice)
[e-mail]
07.09.2012
5
1
H
G
C
D
A
Chair Back
1 Unit
B
Chair Seat
1 Unit
C
Chair Base
1 Unit
D
Casters
5 Units
E
Chair Arms
2 Units
F
Seat Mechanism
1 Unit
G
Gas Lift
1 Unit
H
Telescopic Bellows
1 Unit
I
Arm Screws
4 Units
J
.75” Screws
2 Units
N
Arm Caps
4 Units
M
Allen Wrench
1 Unit
K
1.25” Screws
4 Units
L
1.5” Screws
2 Units
2
JL
M
B
F
3
B
F
K
M
A
4
A
N
M
I
E
STOP
Assembly Instructions
Tools Needed: Allen Wrench
Please read all instructions before assembly.
Step 1: Insert Casters (D) into Chair Base (C). Insert Gas Lift (G) into Chair
Base (C) and cover with Telescopic Bellows (H).
Step 2: Attach Seat Mechanism (F) to the Chair Seat (B) with .75” Screws (J) at
back of seat and 1.5” Screws (L) at front of seat, using the Allen
Wrench (M) that is provided. Tension control knob should face front.
Step 3: Attach mounting plate on Chair Back (A) to Seat Mechanism (F) and Chair
Seat (B) with 1.25” Screws (K), using Allen Wrench (M) that is provided.
Step 4: Attach Chair Arms (E) to Chair Back (A) and Chair Seat (B) using Arm
Screws (I) and Allen Wrench (M). Cover screw holes with Arm Caps (N).
Support bars on arms should be on the inside.
Step 5: Take entire chair frame and place Seat Mechanism (F) onto Gas Lift (G),
and press down firmly to secure.