Manual

OFNA Racing
7 Vanderbilt • Irvine, Ca 92618
Ph: [phone] • Fx: [phone]
SPS-POWER – Part Number #92135
DC 12V 7A SWITCHING POWER SUPPLY
FEATURES:
1. AC switching power supply hi-tech application and lightweight
2. Built-in DC cooling fan
3. Output using PTC reset table fuse for protect
4. With LED light to indicate the power on
5. Banana jack output designed for most RC modeling chargers and devices
OPERATING INSTRUCTION:
1. Make sure no load is connected to this power supply, and then plug to an 110V or AC power source.
2. Please note (+) and (-) polarity of banana outlet on the output side is not allowed to reverse connection.
Otherwise the PTC fuse will cut off the circuit.
3. The DC voltage of the output terminal is 15V.
4. Check if LED is on and Cooling fan is working.
5. If the unit becomes hot to touch, disconnect it immediately.
SAFETY PRECAUTIONS:
1. Don’t use the power supply as the charger to charge directly.
2. Don’t connect unsuitable load (chargers) directly to the power supply (means excessive or over 7A
load).
3. Don’t make the red, black plugs short circuit directly, nor strip this power supply down.
4. Keep the unit clean against the moisture, foreign objects or dust.