:8 SCALE GAS POWERED OFF-ROAD BUGGY INSTRUCTION MANUAL PLEASE READ INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING THIS MODEL. KEEP THIS MANUAL FOR PARTS NUMBERS WHEN ORDERING. SPECIFICATION ARE SUBJECT TO CHANGE WITHOUT NOTICE.
REQUIRED FOR OPERATION THINGS NEEDED You will need to buy a few items to start the engine and run the car. • Use 20% nitro CAR fuel. Do not use airplane fuels, they will over heat engine. • Buy long glow plugs, like OFNA/PICCO P-7 (#51007). Use plugs without idle bar. Do NOT buy hot plugs, like the MC-59. In your box you will find.. • #10218 - Red “C” size glow heater P-7S Glow Fuel 20% 51007 #10211 Battery Pack 1000 NiMh 5cell, flat............... $29.95 #10214 Battery Charger, Overnite $7.
READ THIS BEFORE RUNNING Running a nitro kit is fun and easy, but to make this a safe and good experience you must observe a few rules. This kit is extremely fast, easily over 40MPH, and can seriously injure someone if you are not careful. Where to run car? • Any running area you choose must be dry. Do not run car near any water or wet dirt. • Do not run on public streets. It is very easy to have the car run over or damaged by hitting the curb. • Do not operate car in tight confined places.
* Align throttle servo same as shown. CHECKING ENGINE THROTTLE A C B 1. Insert AA batteries into transmitter (8 Pcs). 2.Turn on transmitter. 3.Turn on receiver. 4.Center throttle trims as shown . 1. Pull Full Throttle. 1. Push trigger to full brake position. 2. Adjust alum. Stopper to increase or decrease the brake. Brake © A Idle Position (A) Full Throttle (B) IMPORTANT CHECK RADIO THROTTLE AND STEERING SWITCHES BEFORE RUNNING CAR • Full throttle arm position.
