Instruction Manual

ASSEMBLY OF THE FRONT SUSPENSION ARMS, M STYLE
ASSEMBLY OF THE REAR SUSPENSION ARMS, M STYLE
#30411
6mm
Ball Joint
#30402
3 X 30mm
Tie Rod
#30401
6mm
Stabilizer
Ball End
#30401
6mm
Stabilizer
Ball End
#36905
Arm Adjusters
0 10 20 30 40 50
mm
18mm
3 x 15mm Screw
3 x 15mm
Screw
Assembly of the right and left hand side
are the same.
Step 5
* Cut the sharded area
as shown.
Assembly of the right and left hand side
are the same.
Step 4
#36640
Upper arm Shaft
3 x 3mm
Set Screw
#30340
6mm
Stabilizer
Ball End
3mm
E-Ring
3mm
E-Ring
#30102
Front Body
Post
3x8mm
Tapping Screw
00
11
RR
3 x 8mm
Tapping Screw
3 x 3mm Set Screw
3 mm E-Ring
00
11
RR
* Insert stabilizer rod
through upper arm.
1mm
2mm
3mm
* Follow the main instruction manual to assembly the rear lower arm M parts instead of K parts.
* Change the position of the adjuster
to will change the caster angle.
* Insert caster angle adjuster onto the
upper arm shaft.
4 x 10mm
Tapping Screw
Assembly of the right and left hand side
are the same.
Step 3
#36630
Lower Arm Shaft
3mm
E-Ring
4 x 10mm
Tapping Screw
#36720
Lower Arm
Stiffener
(Alum.)
3mm
E-Ring
0
1
RR
* Insert drive shaft
before assembly.
3 mm E-Ring
Assembly of the right and left hand side
are the same.
4 x 10 mm
Set Screw
5 x 5mm
Set Screw
5 x 5mm
Set Screw
* A 4 x 10mm set screw is used
to adjust the ride height.
* Approx 3mm.
R
#36055
2.5 x 17mm
Pin
#36054
Wheel Hub
( Alum. )
* Use 2.5mm
Hex Wrench.
#36870
4x10mm
Set Screw
* Do not over tighten
5x5mm set screw.
Step 2
#36890
Front
Lower Arm
RR
5x5mm
Set Screw
#36900
Front
Upper Arm
3mm
3mm
ASSEMBLY OF THE FRONT SUSPENSION ARMS, M STYLE
ASSEMBLY OF THE FRONT
SUSPENSION ARMS, M STYLE