Instruction Manual

PLASTIC PARTS USED
#30010
Main Gear Box
#30751 - Frt & Rr Cases
#30761 - Center Case
(K type cases)
#30769 Bevel Gear
Set, for K type case.
#30200 Center Diff Mounts
#36020 Upper
Arm, frt (K)
#36780 Battery & Receiver Box
Plastic Post
Servo Mount
Radio Tray Post
#36820 Chassis Stone Guards
#30270 Rear Wing Support set
#36740 Servo Saver set
#30800 Linkage, throttle kit
Plastic Collar
Plastic Bearing
#36700 Steering Ball Ends, 7mm
#36690 Rear Upper Arm Ball
Ends 7mm
#36011 lower arm, Front (K), Straight type
#36902 Lower arm, Rear (K), Straight type
#36060 C Hubs (K)
#36051 Knuckles, 8mm
(K)
«e¤WÂ\Áu
#36081 Rear Uprights
8mm (K & M)
#36710 Rear Support
bracket
A
B
C
CHECKING ENGINE THROTTLE
* Insert into transmitter.
1. Insert AA batteries into
transmitter (8 Pcs).
2.Turn on transmitter.
3.Turn on receiver.
4.Center throttle trims as
shown .
A
B
C
1. Pull Full Throttle.
1. Push trigger to full
brake position.
2. Adjust alum. Stopper to
increase or decrease
the brake.
Idle Position (A)
Brake ©
Full Throttle (B)
* Align throttle servo same
as shown.
A
B
C
• Full brake arm position.
Spring compresses
forward and brake rods
pull brake levers.
• Full throttle arm position.
Spring rod pulls throttle
barrel open and brake
rods release pressure on
brake cams.
IMPORTANT
CHECK RADIO THROTTLE
AND STEERING SWITCHES
BEFORE RUNNING CAR
3 x 10mm
Tapping Screw
#10016
Air Filter
Sponge
Refills
#10017 - Blue
#10018 - Yellow
#10019 - Rose
Foam Air filters Unit
#10021 - Black
#10027 - Yellow
#10028 - Pink
#10029 - Blue
Air Filter Connector
Nylon Strap
( Small )
Nylon Strap
( Small )
ASSEMBLY OF THE AIR FILTER
You must oil foam filter before use.
Filter will not work if not oiled.
Clean with soap and water only.
You will damage foam if washed
if fuel!
#10015, Foam
Filter oil, Very
Sticky....$9.95