Owner manual

45
ASSEMBLY OF THE AIR FILTER
43
44
ZIP TIES
40129
40127
40128
40127
3x8mm
*Apply filter oil to the
foam before use.
*Apply filter oil to the
foam before use.
94002
3x8mm
Hex Screw
.....x1
ADJUSTING THE ENGINE CONTROL LINKAGES
Approx. 1mm gap
(Neutral)
(Throttle High)
(Brake)
Idling adjusting
Screw
Approx. 0.5mm
Carburetor is Opening fully
ASSEMBLY OF THE THROTTLE LINKAGES INTO LEVER
10769
3x3mm
10300
10300
94033
3x3mm
Set Screw
.....x2
* Use the screw
provided with
your servo .
5mm
Fuel Tube
Snap On
Step 1
Step 2
15
Turn on the Transmitter then Receiver and set the
Engine Control Servo Trim to the neutral position.
Adjust the idling adjusting screw on the Carburetor
to be open approx. 1mm gap.
Adjust both of the 10300 Engine Control and Brake linkage
accordingly.
Adjust the Engine while it is not running.
Adjust the Servo-Horn mounting position for the
Carburetor to be full open.
Change the pivot mounting position on the servo
horn in case the Carburetor is not opening fully or
if it is opening excessively. Or if available on the
Transmitter, adjust the Throttle high end point.
Adjust so the brakes work smoothly.
If the brakes apply too much or not enough,
adjust 30800 accordingly. Or if available on the
Transmitter, adjust the High-End Brake
adjustment.
Adjust 30800 to Change the front or Rear Brake.
.