RTR Instruction Manual OFNA RACING 22692 Granite Way, Ste. B Laguna Hills, CA.
REQUIRED FOR OPERATION THINGS NEEDED You will need to buy a few items to start the engine and run the car. • Use 20% nitro CAR fuel. Do not use airplane fuels, they will over heat engine. • Buy short glow plugs, like O.S. 8. Or OFNA/PICCO P-7S plug. Use plugs without idle bar. If a long glow plug is used, like the P-7S and MC-59, place two copper washers under the plug. Glow Fuel 20% In your box you will find..
READ THIS BEFORE RUNNING Running a nitro kit is fun and easy, but to make this a safe and good experience you must observe a few rules. This kit is extremely fast, easily over 40MPH, and can seriously injure someone if you are not careful. Where to run car? • Any running area you choose must be dry. Do not run car near any water. • Do not run on public streets. It is very easy to have the car run over or damaged by hitting the curb. • Do not operate car in tight confined places.
INSTALLATION OF THE RECEIVER BATTERY AA-3 Batteries 4 pcs Unscrew battery holder and slip Receiver battery pack under. * Check negative and positive-side before assembly. Throttle is IDLE CHECKING ENGINE THROTTLE A 1. Insert AA batteries into transmitter (8 Pcs). 2.Turn on transmitter. 3.Turn on receiver. 4.Center throttle trims as shown . 1. Pull Full Throttle. A: Throttle in IDLE position. Note throttle opening in carb. This is IDLE setting C B 1. Push trigger to full brake position. 2.
ASSEMBLY OF THE TIRES AND WHEELS STEERING LINKAGE ADJUSTMENT SCREW SCREW MOUNT WHEELS ONTO THE FRONT AND REAR AXLES WITH A 4mm NYLOK NUT. TO TIGHTEN NUT, USE A 7mm HEX NUT DRIVER. DO NOT OVER TIGHTEN NUT! TO ADJUST STEERING FOR STRAIGHT. USE THE RADIO FINE ADJUSTMENT STEERING KNOB. IF THIS WILL NOT CORRECTLY POSITION THE WHEEL. FUTHER ADJUSTMENT IS NEEDED AT THE SERVO LINKAGE. INSTALLATION OF BODY POSTS AND SHOCK ABSORBERS BODY MOUNTING: THE BODY MOUNTS ARE FULLY ADJUSTABLE.
ENGINE BREAK-IN AND TUNNING (BREAK-IN THE ENGINE BEFORE DRIVING THE CAR!) • Choose a wide clear outdoor location with low dirt and dust. • Set the car on box or holder with wheels off the ground. • Turn on radio and car. • Make sure throttle is at idle position. • Fill fuel tank and set master engine needle. • Prime fuel line and Heat glow plug before pull starting engine. • When started, let engine fast idle for two tanks of fuel.
