User Manual Gas Fire Pit 55000 BTU Model No: Ofiretable43-BK/MB/DB/GR
Reach out to us to for expert support contact@ohanadepot.com ohanadepot.com 1-503-894-3454 (USA) 1-866-374-8195 (USA) Scan OR Code for More Products at ohanadepot.com ohanadepot.
WARNING PLEASE READ THE ENTIRE MANUAL PRIOR TO ASSEMBLY AND OPERATION. DO NOT attempt to operate until you have read & understood the general safety information in this manual and all assembly & leak checks are completed. Verify all parts and components are present. Check all pieces for any damage before assembly. If any parts are damaged or missing, contact customer service at contact@ohanadepot.com Some pieces contain sharp edges, which may cause personal injury or property damage.
WARNING Do not store or use gasoline, or other flammable vapors and liquids, in the vicinity of this or any other appliance. An LP-cylinder not connected for use shall not be stored in the vicinity of this or any other appliance. WARNING WARNING If the information in this manual is not followed exactly, a fire or explosion may result in property damage, injury, or loss of life. Solid fuels shall not be burned in this appliance.
WARNING WARNING This product and fuels used to operate this product, and the product of combustion of such fuels, can expose you to chemicals including benzene. WARNING When using the lava/glass rocks in the fire pit for the first time, you may hear popping sounds and lava/glass rocks may bounce in the fire pit for the first 30 minutes. Keep a safe distance from the fire pit until the rocks settle.
WARNING You must provide propane gas and a propane cylinder. Use a standard 20 lb. Propane cylinder only. Use this heater only with a propane vapor withdrawal supply system. See Chapter 5 of the Standard for Storage and Handling of Liquified Petroleum Gas, ANSI/NFPA 58. Your local library or fire department should have this book. The minimum permissible gas supply pressure of 10 W.C. is required for the purpose of input adjustment.
TABLE DIMENSIONS Ref. A B C D E F ohanadepot.com Dimension 42 in. (106.68 cm) 30 in. (76.20 cm) 26 in. (66.04 cm) 31 in. (78.74 cm) 13 in. (33.02 cm) 6 in. (15.
PARTS DIAGRAM ohanadepot.
PARTS LIST Part Description Quantity A Fire Bowl Lid 1 pc B Lava Rocks 1 bag C Glass Wind Guard 1 pc D Tempered Glass 1 pc E Table Top Frame 1 pc F Top Frame 1 pc G Front Panel 1 pc H Back Panel 1 pc I Left Panel 1 pc J Door 1 pc K Propane Cylinder H-Frame Support 1 pc L Cross Support 1 pc Picture HARDWARE Part AA Description 2 inch screw Quantity 4 pcs BB 1 inch screw 22 pcs CC Tighten Cylinder Collar 1 pc DD Glass Screw 8 pcs EE Clip 2 pcs ohanadepot.
ASSEMBLY INSTRUCTIONS Choose a clear area for assembly, and a soft surface or cardboard to protect from damages. 2 person assembly recommended. Step 1 Place the table top frame (E) upside down to the soft, level surface, attach the front panel (G) to the table top frame (E) with the screws (BB) as illustrated. DO NOT TIGHTEN hardware until all panels have been installed. Hardware Used BB 1 inch Screw 4 pcs Step 2 Attach the back panel (H) to the table top frame (E) with the screws (BB) as illustrated.
ASSEMBLY INSTRUCTIONS Step 3 Attach the left panel (I) to the front panel (G) and the back panel (H) with the screws (AA) as illustrated. Hardware Used AA 2 inch Screw 2 pcs Step 4 Attach the cross support (L) to the propane cylinder H-frame support (K) with the screws (BB) as illustrated. Hardware Used BB 1 inch Screw ohanadepot.
ASSEMBLY INSTRUCTIONS Step 5 Attach the cylinder holder (K+L) to the front panel (G) and the back panel (H) with the screws (BB) as illustrated. Note: Using 2 people to lift, turn the gas fire pit into upright position after completing step 5. Hardware Used BB 1 inch Screw 4 pcs Step 6 Attach the door (J) to the front panel (G) with the hinges as illustrated. ohanadepot.
ASSEMBLY INSTRUCTIONS Step 7 Attach the top frame (F) to the table top frame (E) with the screws (BB) and place the lava rocks (B) on the burning area of the top frame (F) as illustrated. Hardware Used BB 1 inch Screw 4 pcs Step 8 Put the tempered glass (D) onto the table top frame (E) as illustrated. ohanadepot.
ASSEMBLY INSTRUCTIONS Step 9 Attach the glass wind guard (C) to the tempered glass (D) with the glass screws (DD) as illustrated. Hardware Used DD Glass Screw 8 pcs Step 10 Put the LPG cylinder into the cylinder holder (K+L) and turn the cylinder locking bolt clockwise to secure the LPG cylinder as illustrated. Attach the regulator to the cylinder and turn clockwise by hand. ohanadepot.
OPERATION WARNING: DO NOT ATTEMPT TO OPERATE THE APPLIANCE UNTIL YOU HAVE READ AND UNDERSTAND ALL PRECAUTIONS. FAILURE TO DO SO CAN RESULT IN PROPERTY DAMAGE, SERIOUS INJURY, OR DEATH. WARNING CAUTION: Do not use an open flame to check for leakage. Do not smoke during testing. Do not test indoors. A leak check must be performed whenever the gas cylinder is replaced.
OPERATION WARNING: DO NOT ATTEMPT TO OPERATE THE APPLIANCE UNTIL YOU HAVE READ AND UNDERSTAND ALL PRECAUTIONS. FAILURE TO DO SO CAN RESULT IN PROPERTY DAMAGE, SERIOUS INJURY, OR DEATH. Before Lighting The gas fire pit should be thoroughly inspected before each use, and by a qualified service person at least annually. If relighting a hot gas fire pit, always wait at least 5 minutes. Lighting instructions 1. Make sure control knob is in the "OFF" position. 2. Turn LP cylinder gas valve to fully open position.
OPERATION CAUTION: AVOID INHALING FUMES EMITTED FROM THE GAS APPLIANCE'S FIRST USE. SMOKE AND ODOR FROM THE BURNING OF OILS USED IN MANUFACTURING WILL APPEAR. BOTH SMOKE AND ODOR WILL DISSIPATE AFTER APPROXIMATELY 30 MINUTES.THE GAS APPLIANCE SHOULD NOT PRODUCE ANY THICK BLACK SMOKE. NOTE: The burner may be noisy when initially turned on. To eliminate excessive noise from the burner, turn the control knob to the LOW position. Then, turn the knob to the level of heat desired.
LOCATING FIRE PIT FOR USE CAUTION: WHEN CERTAIN MATERIALS OR ITEMS ARE LEFT ABOVE, BESIDE OR UNDER THIS APPLIANCE WHILE IN USE, THEY WILL BE SUBJECT TO RADIANT HEAT AND COULD BE SERIOUSLY DAMAGED. This gas fire pit is primarily used for the heating of outdoor patios, decks, pools and open working areas. Always make sure that adequate fresh air ventilation is provided. Follow the spacing tolerances at all times. This gas fire pit must be placed on level, firm ground.
MAINTENANCE AND STORAGE CLEANING AND MAINTENANCE: WARNING: To enjoy years of outstanding performance from gas fire pit, make sure you perform the following maintenance activities on a regular basis: FOR YOUR SAFETY DO NOT touch or move the gas appliance for at least 45 minutes after use. Allow all burner elements to cool before touching. Keep exterior surfaces clean. Use warm soapy water for cleaning. Never use flammable corrosive cleaning agents.
MAINTENANCE AND STORAGE Store the fire pit indoors during the winter if it will be subjected to freezing temperatures. Disconnect and remove the cylinder from the appliance before the appliance can be stored indoors. STORAGE Turn the control knob to “OFF” position. Turn the LP cylinder to OFF position. Allow at least 45 minutes for the fire pit to cool down after use, then disconnect and remove the cylinder.
TROUBLESHOOTING Problem Possible Cause LPG cylinder valve is closed. Coupling nut not fully connected. Burner will not light Propane Gas Leak Sudden drop in flow or reduced flame height Flame is yellow or orange or Irregular flame pattern or Fire in venturi or burner Low or empty LPG cylinder. Electrode and burner are wet. Failed igniter. Broken electrode or spark. Carbon deposit accumulated on the burner port or thermocouple. Obstruction of gas flow. Disconnection between the burner and LPG cylinder.
LIMITED ONE YEAR WARRANTY What is covered under this warranty? This product is covered under Manufactured Limited Warranty. To ensure your complete satisfaction, this warrants to the original purchaser that this furniture is free from defects in material and workmanship as of the date of purchase and that it will, under normal use proper care, remain so for one year after the date of purchase.