Manual

Type Approved/LFTType Approved/LFT

Type Approved/LFT

LFT can be set to ON or OFF. Selecting ON automatically sets the parameters shown

in the table to conform to type approved requirements. For sealing method, refer to

Type Approved Sealing section. Default setting are shown as follows:

Lockswitch Menu Setup Locked

Print Stable Data Only ON

Weighing Units Weighing Units

Weighing Units

GramsGrams

Grams

dwt Pennyweight

ct Carats

oz Ounces

ozt Troy ounces

UNIT1 Grains

t Taels (see note)

UNIT2 Mommes

UNIT3 Custom

1. Access the submenu.

2. .

3. or .

Unit SelectionUnit Selection

Unit Selection

The Unit Selection (SEL) submenu per-

mits the selection of weighing units for use

during operation. The balance can display

weights in every unit of measure listed in

table. The default setting is shown in bold

type.

NOTE:NOTE:

NOTE:

If Taels is enabled, see next page before

exiting the menu.

To view or change the various weighing units:

1. Access the

submenu.

3. or .

for next unit status.

5. Repeat steps 2 through 4 for each unit.

MENUS