Manual

Error Codes ListError Codes List

Error Codes List

The following list describes the various error codes and which can appear on the

display and the suggested remedy.

Data ErrorsData Errors

Data Errors

0.0 Internal data errors. If error persists, the balance must be serviced.

1.0 Internal data errors. If error persists, the balance must be serviced.

Tare ErrorsTare Errors

Tare Errors

2.0 Illegal tare operation or balance is unable to stabilize within time limit after

taring. Environment is too hostile or balance needs recalibration.

Calibration ErrorsCalibration Errors

Calibration Errors

3.0 Incorrect or no calibration weight used for User calibration. Recalibrate with

correct weights.

5.0 Auto calibration failed. Environment is to hostile, recalibrate the balance.

RS232 ErrorsRS232 Errors

RS232 Errors

4.4 RS232 buffer is full (if installed). May occur if no printer or computer is

connected to the interface. To clear buffer, turn balance off or enter Print menu

and select END.

4.5 Function is disabled by the Lock switch.

User ErrorsUser Errors

User Errors

7.0 User entry out of range (custom factor, non-pH, non-pL, etc...)

7.1 Bad percent (%) mode, sample too low.

7.2 Number outside of display capacity.

Over-Under Load ErrorsOver-Under Load Errors

Over-Under Load Errors

8.0 Hardware error causing an internal weight signal which is too low. Check if

platform or platform support is off. If not, the balance must be serviced.

8.2 Internal power on error. Turn the power off, then turn it back on.

8.3 Hardware error caused by an internal weight signal which is too high. Check

load on the platform which may be excessive. If error persists, the balance must

be serviced.

MAINTENANCE